|
CARPET For carpet steam cleaning, vacuum the carpet thoroughly. Prespot heavy stains, then mist the rest of the carpet with diluted cleaner.� Mix 4 oz. of APC to 4 gallons of hot water for cleaning solution and use defoamer in the pickup tank only if necessary. Even if the carpet seems to have more dirt than carpet fiber, APC will give amazing results.� Loosen the dirt the best you can with a brush. Vacuum thoroughly. Mist carpet with 1 to 31 solution of APC till moist. Clean with extraction machine.� Repeat if still slightly dirty, until an elite finish is achieved. Allow to dry and vacuum well. UPHOLSTERY For upholstery, use a 1 to 20 mix of APC to spray the entire surface so that the area you spot clean does not show up cleaner than the surrounding area.� Take a terry cloth towel and brush with the grain of the fabric.� If desired, use a blow drier to speed up drying time.� Do not use high heat! Vacuum thoroughly, making sure the vacuum head is clean.� Prespot with a 1 to 20 dilution of APC or 1 to 10 for bad stains.� Mist a heavy blanket of cleaner across the rest of the area and vacuum with a good wet/dry shop vac or carwash vac and get professional results. Stay away from brushing delicate fabrics. HARD SURFACE CLEANING Use APC 1:30 for all purpose hard surface cleaning around the kitchen, bathroom, office, workroom, garage, etc. AUTOMATIC FLOOR MACHINES APC works great at 1:30 - 1:50 in self contained automatic floor cleaning machines in offices and factories.� It will clean up oily films on floors and remove them instead of allowing them to work into the floor like some solvent cleaners will.� Removes tire marks and other tough grime quickly. CONCRETE At last, a great way to clean concrete! Spray APC undiluted on oil/grease stains. Let soak for 5 minutes. Spray one more time. Soak for 90 seconds and brush briskly. Rinse with water. PRESSURE WASHING For pressure washing of vehicles, equipment, floors, etc.� Use APC at 1:50 up to 1:150 ratio. For degreasing, use hot water through a pressure washer at a 1:50 ratio for great results. For general hot pressure washing or steam cleaning use APC at 1:80 to 1:150 ratio. APC has good corrosion inhibiting tendencies and will leave painted surfaces clean and shiny when rinsed well. SPOT CLEANING�APC is a great spot cleaner.� Dilute 1 oz. in 20-32 oz. of water.� Spray directly on the stain and use terry cloth towels to remove.� If necessary, repeat the procedure.� It�s that simple! Always use this product according to directions. Kebro Inc. is not responsible for misuse or mishandling of this product. Use in well ventilated areas.
Mfd by Kebro, Inc., P.O. Box 7765, Des Moines, IA� 50323 |
|
Copyright 2006 L. Broadbent � Kebro Company, Inc. |